ZoneSentry
Know which room every worker is in, with as few as one or two beacons per room.
Which room is this worker in?
Being close to one beacon and far from another is what names the room.
Capabilities that drive results.
Room movement history
See exactly when each worker entered and left every zone, across any shift.
No-entry areas without a door
Fence off an area on the plan and get an alert the moment someone walks in.
Hours per named room
Time is logged per room, so the report shows where the day went.
Occupancy limits, both ways
Get an alert when a room is overcrowded, or when someone is working alone.
Where it fits
Every method has a job it is wrong for. This is ours.
Use it when
- You have one or two beacons per room and are not adding more.
- Rooms have walls, which gives each one a signal you can tell apart.
- Knowing which room is enough to act on.
Use something else when
- You want the route somebody walked. Use TraceGuard.
- You need a precise point inside a large or open room.
- The space is open floor with nothing to tell rooms apart.
What it runs on
One card per worker, one or two beacons per room.
Works alongside
Most sites run more than one method, set room by room.
